Frequently Asked Questions - FAQs



Question:

You say F G Lang's has a real life shop attached to it too? Where can I find it?

Answer:

Descriptions on where and how to find us are in the Finding us section



Question:

What are your opening hours for the shop?

Answer:

At present opening hours for the shop are Monday to Friday 8am to 5.30pm.



Question:

When I phone up, why do you ask so many questions?

Answer:

We try to be as thorough as possible with our questions, so we get all the information to look for the products that you require. For example, in the fastening industry there are thousands of different fixings to choose from, if we know the material you're working with, this eliminates a couple of hundred fixings you could use straight away. So be patient, we're asking the questions to get you the best product for the job.



Question:

Socket caps, hex sets or bolts. Aren't they the same thing?

Answer:

They are all fastenings. However they are all different. A hex headed bolt is hexagon headed, threaded fastening with an amount of plain shank (shoulder) that can fit tightly into a hole if drilled to the correct size. A hex headed set is a hexagon headed, threaded fastening which has thread down its entire body. The Socket cap head screw is a fastening with a knurled cheese head with an allen/hexagon key fitting in the top, and tend to be 12.9 tensile strength. These can be supplied in a set form also. Both the Hex bolt and set are available in 8.8 and 10.9 tensile strength.



Question:

I am confused about a quarter, third, and half sheet sanders. What is the difference between then and what does it refer to?

Answer:

Half, third and quarter sanding sheets are taken from the size of a standard sanding sheet.

Size of a standard sanding sheet - 9 inches (230mm) by 11 inches (280mm)


230mm wide by 280mm length


Take this sheet and cutting down the center width ways gets you the size of half a sheet - 9 inches (230mm) by 5 1/2 inches (140mm)
So 2 of these sheets makes up 1 standard sheet.


230mm wide by 140mm length


Take the sheet again and cut it down to make one third the size of a standard sheet - 9 inches (230mm) by 3 2/3 inch (93mm)
So 3 of these sheets makes up 1 standard sheet.


230mm wide by 93mm length


Take the standard sheet again and cut down the center length ways gets you the size of half a sheet then cut down the center again getting you a quarter sheet - 4 1/2 inches (114mm) by 5 1/2 inches (140mm)
So 4 of these sheets make up 1 standard sheet.


140mm wide by 114mm length






Continue
Belt-Driven Air Compressor, 200L, 2.2kW
Belt-Driven Air Compressor, 200L, 2.2kW
Around £735
(plus VAT)

Around £883
(inc VAT)
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
There are currently no product reviews